Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 127
Left: View from the left sensor in a dual-sensor system.
Right: View from the right sensor in a dual-sensor system.
Left &Right: Views from both sensors, displayed at the same time in the data viewer, using the
coordinate systems of each sensor.
In the Measure page, the view of the display is set to the profile source of the selected measurement
tool.
Section Mode
When the Gocator is in Surface scan mode, the data viewer can display sections (profiles extracted from
surfaces).
In a dual-sensor system, profiles from individual sensors or from a combined view can be displayed.
When in the Scan page, selecting a panel (e.g., Sensor or Alignment panel) automatically sets the
display to the most appropriate display view.
To Next Page
Loading...
