Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 158
Setting Description
Top Refers to the Main sensor in a standalone or dual-sensor system, the Main sensor in
Opposite layout, or the combined data from both Main and Buddy sensors.
Bottom Refers to a Buddy sensor in a dual-sensor system position in Opposite layout.
Top Left Refers to a Main sensor in Wide layout or to a Buddy sensor in Reverse layout in a dual-
sensor system position.
Top Right Refers to a Buddy sensor in Wide layout or to a Main sensor in Reverse layout in a dual-
sensor system position.
To select the source:
1. Go to the Measure page by clicking on the Measure icon.
The scan mode must be set to the type of measurement you need to configure.
Otherwise, the wrong tools, or no tools, will be listed on the Measure page.
2. In the Tools panel, click on a tool in the tool list.
3. If it is not already selected, click on the Parameter tab in the tool configuration area.
4. Select the profile source in the Source drop-down list.
Streams (Sections)
If you create more than one section on a surface and then add a profile measurement, you must choose
which section profile that measurement uses using the Stream setting in the measurement.
The Stream setting applies to all of a tool's measurements.
To choose a stream:
1. Go to the Measure page by clicking on the Measure icon.
The scan mode must be set to the type of measurement you need to configure.
Otherwise, the wrong tools, or no tools, will be listed on the Measure page.
2. In the Tools panel, click on a tool in the tool list.
3. In the measurement list, select a measurement.
To select a measurement, it must be enabled. See Enabling and Disabling Measurements on page 163
for instructions on how to enable a measurement.
4. If it is not already selected, click on the Parameter tab in the tool configuration area.
5. Select the section in the Stream drop-down list.
Regions
Many measurement tools use region parameters to limit the area in which a measurement will occur or
to help in the identification of a feature (see on page 166), a fit line (see on page 168), or left or right side
of the Panel tool ( see Panel on page 186). Unlike reducing the active area, reducing the region does not
increase the maximum frame rate of the sensor.
To Next Page
Loading...
