Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 183
Parameter Description
Select Type Specifies how a groove is selected when there are multiple grooves within the measurement
area.
Maximum Depth - Groove with maximum depth.
Index from The Left - 0-based groove index, counting from left to right
Index from the Right - 0-based groove index, counting from right to left.
Index 0-based groove index.
Minimum Depth Minimum depth for a groove to be considered valid.
Minimum Width Minimum width for a groove to be considered valid. The width is the distance between the
groove corners.
Maximum Width Maximum width of a groove to be considered valid. If set to 0, the maximum is set to the width
of the measurement area.
Decision See Decisions on page 159.
Region The measurement region defines the region in which to search for the groove. For a stable
measurement, the measurement region should be made large enough to cover some laser data
on the left and right sides of the groove. See Regions on page 158.
Filters See Filters on page 161.
Intersect
The Intersect tool determines intersect points and angles. Gocator compares the measurement value
with the values in Min and Max to yield a decision. For more information on decisions, see Decisions on
page 159.
The Intersect tool's measurements require two fit lines, one of which is a reference line set to the X axis (z
= 0), the Z axis (x = 0),or a user-defined line.
See Adding and Configuring a Tool on page 156 for instructions on how to add measurement tools.
To Next Page
Loading...
