Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 59
Element Description
4 Measure page Contains built-in measurement tools and their settings. See Measurement
on page 155.
5 Output page Contains settings for configuring output protocols used to communicate
measurements to external devices. See Output on page 243.
6 Dashboard page Provides monitoring of measurement statistics and sensor health. See
Dashboard on page 255.
7 CPULoad and Speed Provides important sensor performance metrics. See Metrics Area on page
66.
8 Toolbar Controls sensor operation, manages jobs, and filters and replays
recorded measurement data. See Toolbar below.
9 Configuration area Provides controls to configure scan and measurement tool settings.
10
Data viewer
Displays sensor data, tool setup controls, and measurements. See Data
Viewer on page 121 for its use when the Scan page is active and on page
156 for its use when the Measure page is active.
11
Status bar
Displays log messages from the sensor (errors, warnings, and other
information) and frame information, and lets you switch the interface
language. For more information,
Toolbar
The toolbar is used for performing operations such as managing jobs, working with replay data, and
starting and stopping the sensor.
Element Description
1 Job controls For saving and loading jobs.
2 Replay data controls For downloading, uploading, and exporting recorded data.
3 Sensor operation / replay control Use the sensor operation controls to start sensors, enable and
filter recording, and control recorded data.
Creating, Saving and Loading Jobs (Settings)
A Gocator can store several hundred jobs. Being able to switch between jobs is useful when a Gocator is
used with different constraints during separate production runs. For example, width decision minimum
and maximum values might allow greater variation during one production run of a part, but might allow
less variation during another production run, depending on the desired grade of the part.
Most of the settings that can be changed in the Gocator's web interface, such as the ones in the
Manage, Measure, and Output pages, are temporary until saved in a job file. Each sensor can have
To Next Page
Loading...
