Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 228
Measurement Region
The center and the two sides and ends of the opening must be within the measurement region, even if
Partial Detection is enabled.
Plane
The Plane tool provides measurements that report angle X, angle Y, and offset Z of the surface with
respect to the alignment target. Gocator compares the measurement value with the values in Min and
Max to yield a decision. For more information on decisions, see Decisions on page 159.
See Adding and Configuring a Tool on page 156 for instructions on how to add measurement tools.
The Z offset reported is the Z position at zero position on the X axis and the Y axis.
The results of the Plane Angle X and Plane Angle Y measurements can be used to customize the tilt angle
in the Hole, Opening, and Stud tools.
To Next Page
Loading...
