Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 197
Parameter Description
Support Width Specifies the width of the region around the edges from which the data is used to calculate the
step change. See "Strip Step Edge Definitions" in the Gocator Measurement Tool Technical Manual
on how this parameter is used by different base types.
Transition Width Specifies the nominal width needed to make the transition from the base to the strip. See
"Strip Step Edge Definitions" in the Gocator Measurement Tool Technical Manual on how this
parameter is used by different base types.
Max Void Width The maximum width of missing data allowed for the data to be considered as part of a strip
when Void is selected in the Left or Right parameter. This value must be smaller than the edge
Support Width.
When occlusion and exposure causes data drops, users should use the gap filling function to
fill the gaps. See Gap Filling on page 110 for information.
Min Width Specifies the minimum width for a strip to be considered valid.
Tilt Enabled Enables/disables tile correction.
Decision See Decisions on page 159.
Region The measurement region defines the region in which to search for the strip. If possible, the
region should be made large enough to cover the base on the left and right sides of the strip.
See Regions on page 158 for more information.
Output See Filters on page 161.
Tilt
The strip may be tilted with respect to the sensor's coordinate X axis. This could be caused by conveyor
vibration. If the Tilt option is enabled, the tool will report the width and height measurements following
the tilt angle of the strip.
To Next Page
Loading...
