LMI Technologies Gocator Series - Eip; Modbus; Digital0 and Digital1

Gocator Line Profile Sensors: User Manual
Gocator Device Files • 342
EIP
Element Type Description
BufferEnabled Bool Enables EtherNet/IPoutput buffering.
EndianOutputType 32s Endian output type:
0 – Big endian
1 – Little endian
ImplicitOutputEnabled Bool Enables Implict (I/O) Messaging.
ImplicitTriggerOverride 32s Override requested trigger type by client:
0 – No override
1 – Cyclic
2 – Change of State
EIP Child Elements
Modbus
Element Type Description
BufferEnabled Bool Enables Modbus output buffering.
Modbus Child Elements
Digital0 and Digital1
The Digital0 and Digital1 elements define settings for the Gocator's two digital outputs.
Element Type Description
Event 32s
Triggering event:
0 – None (disabled)
1 – Measurements
2 – Software
3 – Alignment state
4 – Acquisition start
5 – Acquisition end
SignalType 32s
Signal type:
0 – Pulse
1 – Continuous
ScheduleEnabled Bool Enables scheduling.
PulseWidth 64f Pulse width (µs).
PulseWidth.min 64f Minimum pulse width (µs).
PulseWidth.max 64f Maximum pulse width (µs).
PassMode 32s
Measurement pass condition:
0 – AND of measurements is true
Digital0 and Digital1 Child Elements