Gocator Line Profile Sensors: User Manual
Gocator Emulator • 259
Jobs list on the Manage page to a client computer. The job file can then be loaded into the emulator
at a later time or even onto a physical sensor for final testing.
l
Performing alignment in the emulator has no effect and will never complete.
l
Only one instance can be run at a time.
l
The emulator cannot run at the same time as the Gocator Accelerator (either the standalone applic-
ation or an SDK-created application that accelerates a sensor).
For information on saving and loading jobs in the emulator, see Creating, Saving, and Loading Jobs on
page 263 .
For information on uploading and downloading jobs between the emulator and a computer, and
performing other job file management tasks, see Downloading and Uploading Jobs on page 268.
Downloading a Support File
The emulator is provided with several virtual sensors preinstalled.
You can also create virtual sensors yourself by downloading a support file from a physical Gocator and
then adding it to the emulator.
Support files can contain jobs, letting you configure systemsand add measurements in an emulated
sensor. Support files can also contain replay data, letting you test measurements and some
configurations on real data. Dual-sensor systems are supported.
To download a support file:
1. Go to the Manage page and click on the Support category.
2. In Filename, type the name you want to use for the support file.
When you create a scenario from a support file in the emulator, the filename you provide here is displayed
in the emulator's scenario list.
Support files end with the .gs extension, but you do not need to type the extension in Filename.
3. (Optional) In Description, type a description of the support file.
To Next Page
Loading...
