Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 156
Element Description
2
Data Viewer Displays profile or surface data, sets up tools, and displays result calipers related to
the selected measurement.
Parts are displayed using a height map, which is a top-down view of the XY plane,
where color represents height.
See Data Viewer below.
3 Feature Area Configurable region of interest from which feature points are detected. These
feature points are used to calculate the measurements. The number of feature
areas displayed depends on which measurement tool is currently selected.
Data Viewer
Regions, such as active area or measurement regions, can be graphically set up using the data viewer.
When the Measure page is active, the data viewer can be used to graphically configure measurement
regions. Measurement regions can also be configured manually in measurements by entering values into
the provided fields (see on page 158).
For instructions on how to set up measurement regions graphically, see on page 132.
Tools Panel
The Tools panel lets you add, configure, and manage tools. Tools contain related measurements. For
example, the Dimension tool provides Height, Width, and other measurements.
Some settings apply to tools, and therefore to all measurements; these settings are found in the
Parameters tab below the list of tools. Other settings apply to specific measurements, and are found in
a Parameters tab below the list of measurements; not all measurements have parameters.
See Profile Measurement on page 166 and Surface Measurement on page 199 for information on the
measurement tools and their settings.
Tool names in the user interface include the scan mode, but not in the manual. So for example,
you will see "Profile Area" or "Surface BoundingBox"in the user interface, but simply "Area" or
"BoundingBox" in the manual.
Adding and Configuring a Tool
Adding a tool adds all of the tool's measurements to the Tools panel. You can then enable and configure
the measurements selectively.
To Next Page
Loading...
