Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 71
Sensor System
The following sections describe the Sensor System category on the Manage page. This category lets
you choose the layout for standalone or dual-sensor systems, and provides other system settings.
Dual-sensor layouts are only displayed when a Buddy sensor has been assigned.
Sensor Autostart
With the Autostart setting enabled, laser ranging profiling and measurement functions will begin
automatically when the sensor is powered on. Autostart must be enabled if the sensor will be used
without being connected to a computer.
To enable/disable Autostart:
1. Go to the Manage page and click on the Sensor System category.
2. Check/uncheck the Autostart option in the Main section.
System Layout
For Gocator 2345 and 2385 sensors, only use the Normal orientation.
Mounting orientations must be specified for a sensor system. This information allows the alignment
procedure to determine the correct system-wide coordinates for laser profiling and measurements. For
more information on sensor and system coordinates, see Coordinate Systems on page 49.
To Next Page
Loading...
