LMI Technologies Gocator Series - Page 192

Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 192
Measurement Illustration
X
Measures the X position of the location where the tangent
touches the edge, or intersect of the tangent and the line
fitted to the surface used by the measurement (see
Reference Side, below).
Z
Measures the Z position of the location where the tangent
touches the edge, or intersect of the tangent and the line
fitted to the surface used by the measurement (see
Reference Side, below).
Angle
Measures the angle of the line fitted to the surface next to
the corner (see Reference Side, below), with respect to the
x-axis. Left edge angles are from -90 to 90. Right edge
angles are from 90 to 270.
Measurements
Parameter Description
Max Gap Width The maximum width of the gap. Allows the tool to filter gaps greater than the expected
width. This can be used to single out the correct gap when there are multiple gaps in the
field of view.
Reference Direction Defines the side used to calculate the rounded corner.
Decision See Decisions on page 159.
Region See Regions on page 158.
Output See Filters on page 161.
Parameters