Gocator Line Profile Sensors: User Manual
Gocator Web Interface • 225
Measurement Illustration
Angle
Determines the angle (rotation) around the normal of the
alignment plane.
Parameter Description
Type Rounded Slot, Rectangle.
Nominal Width Nominal width of the opening.
Nominal length Nominal length of the opening.
Nominal Angle Nominal angle of the opening. The default orientation is the length of the opening along the X
axis.
The diagram above illustrates the case where the surface is not tilted. When the surface is
tilted, the orientation is defined with respect to the normal of the surface, not with respect to
the X-Y plane
Parameters
To Next Page
Loading...
