Gocator Line Profile Sensors: User Manual
4
System Management and Maintenance 70
Manage Page Overview 70
Sensor System 71
Sensor Autostart 71
System Layout 71
Buddy Assignment 73
Exposure Multiplexing 74
Over Temperature Protection 74
Networking 75
Motion and Alignment 75
Alignment Reference 76
Encoder Resolution 76
Encoder Value and Frequency 77
Travel Speed 77
Jobs 77
Security 79
Maintenance 80
Sensor Backups and Factory Reset 81
Firmware Upgrade 82
Support 83
Support Files 84
Manual Access 84
Software Development Kit 85
Scan Setup and Alignment 86
Scan Page Overview 86
Scan Modes 87
Triggers 88
Trigger Examples 91
Trigger Settings 92
Maximum Input Trigger Rate 93
Maximum Encoder Rate 94
Sensor 94
Active Area 94
Tracking Window 95
Transformations 97
Exposure 98
Single Exposure 99
Dynamic Exposure 100
Multiple Exposure 101
Spacing 102
Sub-Sampling 102
Spacing Interval 103
Material 104
Alignment 106
Alignment States 106
Alignment Types 106
Alignment: With and Without Encoder
Calibration 106
Aligning Sensors 107
Clearing Alignment 110
Filters 110
Gap Filling 110
Median 111
Smoothing 112
Decimation 113
Surface Generation 113
Part Detection 117
Edge Filtering 120
Data Viewer 121
Data Viewer Controls 122
Video Mode 122
Exposure Information 122
Exposures 122
Overexposure and Underexposure 123
Spots and Dropouts 124
Profile Mode 125
Section Mode 127
Surface Mode 128
Height Map Color Scale 131
Region Definition 132
Intensity Output 133
Models 134
Model Page Overview 134
Part Matching 135
Using Edge Detection 136
Creating a Model 139
Modifying a Model's Edge Points 141
Adjusting Target Sensitivity 144
Setting the Match Acceptance Criteria 145
Running Part Matching 145
Using Bounding Box and Ellipse 145
Configuring a Bounding Box or an Ellipse147
Running Part Matching 148
Using Part Matching to Accept or Reject a
Part 149
To Next Page
Loading...
