LPKF ProtoMat S64 - Page 154

Appendix
ProtoMat S64/S104
154/160
LPKF Laser & Electronics AG | V. 1.0
Fig. 109: Installing the cartridge holder ................................................................... 115
Fig. 110: Determining the position of the auxiliary board ........................................ 115
Fig. 111: Determining the position of the auxiliary board ........................................ 116
Fig. 112: Dialog Position of auxiliary board area ..................................................... 116
Fig. 113: Preparing the dispenser ........................................................................... 117
Fig. 114: Determining the height of the dispenser tip .............................................. 117
Fig. 115: Determining the camera offset to the dispenser needle........................... 118
Fig. 116: Selecting the drill hole .............................................................................. 118
Fig. 117: Drill hole selected ..................................................................................... 119
Fig. 118: Selecting the opposite drill hole ................................................................ 119
Fig. 119: Opposite drill hole selected ...................................................................... 120
Fig. 120: Performing the dispensing procedure ...................................................... 120
Fig. 121: Dispensing procedure completed ............................................................. 121
Fig. 122: Mains cable | Rear of system ................................................................... 123
Fig. 123: Mains cable | Socket ................................................................................ 123
Fig. 124: Message Connection lost ......................................................................... 123
Fig. 125: Cleaning the interior of the system ........................................................... 126
Fig. 126: Cleaning the interior with a vacuum cleaner ............................................ 127
Fig. 127: Cleaning the cover.................................................................................... 127
Fig. 128: Collet wrench inserted .............................................................................. 128
Fig. 129: Removing the collet .................................................................................. 129
Fig. 130: Cleaning the collet fixture ......................................................................... 129
Fig. 131: Cleaning the collet with a cylindrical brush .............................................. 130
Fig. 132: Lubricating the collet................................................................................. 130
Fig. 133: Cleaning the working-depth limiter with brush ......................................... 131
Fig. 134: Removing the screws of the working-depth limiter ................................... 132
Fig. 135: Removing the old working-depth limiter ................................................... 132
Fig. 136: Pushing the bellows to the right ............................................................... 133
Fig. 137: Cleaning the linear guide .......................................................................... 134
Fig. 138: Cleaning the drive spindle ........................................................................ 134
Fig. 139: Applying lubricant ..................................................................................... 134
Fig. 140: Lubricating the drive spindle ..................................................................... 134
Fig. 141: Applying precision mechanics oil ............................................................. 134
Fig. 142: Lubricating the linear guides .................................................................... 134
Fig. 143: Pushing the bellows of the y axis aside.................................................... 135
Fig. 144: Moving the processing head to the zero position ..................................... 135
Fig. 145: Pushing the bellows of the x axis to the left ............................................. 136
Fig. 146: Pushing the bellows of the y axis to the rear ............................................ 136
Fig. 147: Fan filter accessible .................................................................................. 137
Fig. 148: Removing the filter mat ............................................................................ 137
Fig. 149: Compressed-air unit ................................................................................. 138
Fig. 150: Opening the drain valve ........................................................................... 138
Fig. 151: Fuse holder ............................................................................................... 139
Fig. 152: Removing the fuse holder ........................................................................ 140
Fig. 153: Fuse holder containing the fuse. .............................................................. 140
Fig. 154: Side view .................................................................................................. 141
Fig. 155: Interior view without filter bag ................................................................... 142
Fig. 156: Interior view without filter bag ................................................................... 143
Fig. 157: Fault monitor pane.................................................................................... 144
Fig. 158: Pane Messages ........................................................................................ 145
Fig. 159: Declaration of conformity (German) ......................................................... 157
Fig. 160: Declaration of conformity (English) .......................................................... 158