CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 213
Revision 36
05-20-20
Table 205. Airframe Periodic Inspection — Area 5, Powerplant (Cont.)
Registration No. Serial No. Helicopter Total Hours
Model InitialRMM SectionRequirement
Engine Exhaust System
900 Examine left and right primary exhaust nozzles:
Primary exhaust nozzle for damage and condition
Exhaust nozzle V−band clamp for correct installation and security.
78−00−00
900 Examine left and right engine secondary ejectors:
Inlet, outlet, and interior for damage and condition
Insulation blankets for damage, condition, correct installation, and
security of lockwire
Mounting brackets for damage, condition, and security of attach
hardware.
78−00−00
For rotorcraft with PW206E or PW207E engines installed:
900 Examine primary exhaust nozzle assembly (Inconel):
For cracks and defects.
78−00−00
Environmental Control System
If the optional heat/defog system is installed:
900 Do the “Heat/Defog System Leak Check Functional Test”. 21−40−00
Fire Protection
900 Examine area engine deck mounted fire/overheat detection system
detection cable, grommets, brackets, and cable connectors for
condition and security.
26−10−20
If the optional fire−extinguishing system is installed:
900 Examine the fire−extinguishing system engine compartment
distribution tubes and supports for condition and security.
26−20−20
Electrical Power
900 Examine area electrical wiring and electrical component installation
for condition, support, and security of attach hardware.
98−00−00
Airframe Periodic Inspection Certification — Area 5, Powerplant
I certify that this aircraft has been inspected in accordance with Airframe Periodic Inspection requirements and
is determined to be in an airworthy condition.
Signature
Rating Type or Certification No.
Date
To Next Page