MD Helicopters MD Explorer - Nonslip Surfaces; Repair and Installation

CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 803
Revision 35
32-00-00
9G32−032
9.5 INCH BY 2.0 INCH (4 PL)
(241 MM BY 51 MM)
Figure 803. Location of the Nonslip Surfaces
3. Nonslip Surfaces
A. Repair and Installation
(Ref. Figure 803)
Consumable Materials
(Ref. CSP−SPM)
Item Nomenclature
C324 Coating Compound, Nonslip
C423 Solvent, Cleaning
C713 Tape, Nonslip
C802 Cloth, Non−Lint
NOTE: You can use nonslip tape (C713) as an
alternative for nonslip coating compound
(C324).
(1). Apply masking tape adjacent to the
repair area.
Solvent, Cleaning (C423)
(2). Clean the repair area with a clean
non-lint cloth (C802) moist with
cleaning solvent (C423).
(a). Clean the area again and again until
the cloth stays clean.
Coating Compound, Nonslip (C324)
(3). Fully mix the nonslip coating compound
(C324) (ref. the manufacturer instruc
tions).
(4). Apply a smooth layer of nonslip coating
compound (C324) on all surfaces with a
brush.
(5). Dry the nonslip coating compound
(C324) (ref. the manufacturer instruc
tions).