CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 101/(102 blank)
Original
25-20-00
CABIN COMPARTMENT INTERIOR
FAULT ISOLATION
1. Interior Assemblies Troubleshooting
The following troubleshooting procedures are a
brief summary of seat assemblies faults, which
may be encountered (Ref. Table 101).
Troubleshooting tables should be used with the
simplified system schematics, electrical wiring
diagrams, serviceability checks and other
detailed procedures referred to in this and
other chapters of the manual.
Table 101. Seat Assemblies Troubleshooting
Fault Probable Cause Corrective Action Ref. Section
Cabin seat does not close up
into stowed position.
Hinging mechanism is
binding or damaged.
Isolate problem component,
remove and replace.
25−20−00
Restraint system does not
lock or release properly.
Malfunction of buckle
mechanism.
Replace harness assembly. 25−20−00
Wear, cut or deterioration in a
questionable section of seat
fabric or cushion.
Puncture damage or
excessive wear.
Remove and replace
component.
25−20−00
Loose or unsecured interior
panel.
Loose hook tape. Remove loose hook tape and
replace.
25−20−00
Loose fastener or
provisioning attachment.
Determine loose fastener
location and replace.
To Next Page
Loading...
