CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 201
Revision 34
05-20-20
CONTINUED AIRWORTHINESS
AIRFRAME PERIODIC INSPECTION
1. Introduction
The rotorcraft is divided into 7 different
inspection areas. The airframe periodic
inspection includes inspections for these 7
areas and the landing gear (ref. Figure 201),
and general and final requirements:
General (ref. Table 201)
Nose section and cockpit - Area 1 (ref.
Table 202)
Cabin compartment - Area 2 (ref.
Table 203)
Upper transmission deck and main rotor -
Areas 3 and 4 (ref. Table 204)
Powerplant - Area 5 (ref. Table 205)
Baggage compartment - Area 6 (ref.
Table 206)
Tailboom and empennage - Area 7 (ref.
Table 207)
Landing gear (ref. Table 208)
Final inspections (ref. Table 209)
Make a copy of each table for your inspection
records. Put your initials on the record after
successful completion of each task. At the end
of each table is a signature block for certifica
tion of each airframe periodic inspection and
continued airworthiness.
9G05-001
8
1. NOSE SECTION AND COCKPIT
2. CABIN COMPARTMENT
3. UPPER TRANSMISSION DECK
4. MAIN ROTOR
5. POWERPLANT
6. BAGGAGE COMPARTMENT
7. TAILBOOM AND EMPENNAGE
8. LANDING GEAR
Figure 201. Inspection Areas
To Next Page
Loading...
