MD Helicopters MD Explorer - Page 103

CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 203
Revision 34
05-20-20
Table 202. Airframe Periodic Inspection — Area 1, Nose Section and Cockpit (Cont.)
Registration No. Serial No. Helicopter Total Hours
Model Requirement RMM Section Initial
Fuselage
900 Examine cockpit windscreens for condition, security, and damage. 53−10−00
900 Examine area fuselage exterior panels, and structure that is in view
for damage, deterioration, and distortion.
53−10−00
53−20−00
900 Examine cockpit floor panels for damage, condition, and attach
hardware for correct installation and security.
53−20−00
Equipment / Furnishings
900 Examine crew compartment for loose equipment and correct stowage
of fire extinguisher, first aid kit, and other auxiliary equipment.
25−10−00
25−60−00
26−20−10
900 Examine crew seats and floor attach fittings for condition and security
of attach hardware. Do a check of the crew seat adjustment for
correct operation.
25−10−00
900 Examine crew restraints for condition and security of attachment to
seats. Do a check of the belt adjusters, buckles, and inertia reels for
correct operation.
25−10−00
900 Examine crew compartment interior trim for condition and security of
attachment.
25−10−00
Doors
900 Examine left and right crew doors:
 For condition and damage
 Door seals for condition and damage
 Attach hardware and components for damage and security.
52−00−00
900 Do a check of crew door latch mechanisms for correct operation. 52−00−00
900 Examine crew door windows and seals for condition, damage, and
correct installation.
52−00−00
Flight Controls
900 Examine collective, cyclic, and anti−torque flight controls brackets,
bellcranks, links and control rods located under the cockpit floor, and
in the controls closet for condition, indication of interference, correct
installation, and control rod bolts installed in the correct direction.
67−10−00
67−10−20
67−20−00
Engine Controls
900 Examine mechanical engine control interconnect cables, detent
modules, and area control cables for condition and correct
installation.
76−00−00
900 Do the “Engine Controls Operational Test”. 76−00−00