MD Helicopters MD Explorer - Fault Isolation; Standard Landing Gear Assembly Troubleshooting

CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 101
Revision 34
32-00-00
LANDING GEAR
FAULT ISOLATION
1. Standard Landing Gear Assembly
Troubleshooting
The troubleshooting procedures of Table 101
are a brief summary of landing gear system
faults that can occur.
Table 101. Standard Landing Gear Assembly Troubleshooting
Fault Probable Cause Corrective Action Ref. Section
Unusual or too much
vibration
Damper damage
Saddle assembly pad
damage
Side stop clamp pad
damage
Examine saddle pads, side
stop clamp pads, and/or
landing gear damper
assemblies
32−00−00
Incorrect ground attitude Crosstube damage Examine forward and aft
crosstubes
32−00−00
Landing gear damper
assembly low
Fluid level low
Damper damage
Examine fluid level and fill
damper with fluid, if necessary
Examine dampers
32−00−00 &
12−00−00
32−00−00