MD Helicopters MD Explorer - Inspection 1 - Nose Section and Cockpit

CSP−900RMM−2MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 207
Revision 28
05-20-50
INSPECTION 1 − NOSE SECTION AND COCKPIT
Table 202. Inspection 1 − Nose Section and Cockpit (Area 1)
Registration No. Serial No. Helicopter Total Hours
Model Requirement RMM Section Initial
900 Make sure you comply with applicable Special Inspections (Calendar)
for Area 1 and make entries in Log Book.
05−20−10
General
900 Fully clean helicopter as necessary before you start inspection. CSP−SPM
20−20−00
900 Refer to related manufacturers’ publications for detailed necessary
inspection of engines, starter/generators, battery and all installed STC
and optional equipment.
01−00−00
900 Examine the aircraft maintenance records for aircraft discrepancies
and correct as necessary.
N/A
900 Examine Integrated Instrument Display System (IIDS) Exceedance
Log Menu and Fault Log Menu. Record and correct discrepancies as
necessary. (NOTE: Logs may be viewed on the IIDS or refer to
GBMC User Guide for complete download and save of IIDS data).
95−30−00
900 Make sure you comply with component mandatory retirement, refer to
Airworthiness Limitation Schedule and make entries in Log Book.
04−00−00
900 Make sure you comply with component overhaul, refer to Overhaul
Schedule and make entries in Log Book.
05−10−00
900 Make sure you comply with all applicable Airworthiness Directives
and service bulletins and make entries in Log Book.
N/A
900 Make sure all placards and markings are installed. 11−00−00
900 Remove trim panels, covers, and access panels as necessary. 06−00−00
Fuselage
900 Inspect area exterior and structure that is in view for damage,
deterioration, and distortion.
53−20−00
900 Inspect cockpit floor panels for damage, condition, and attach
hardware for correct installation and security.
53−20−00
900 Inspect cockpit windscreens for condition, security, and damage. 53−10−00
Equipment/Furnishings
900 Inspect crew seats and floor attach fittings for condition and security
of attach hardware. Do a check of the crew seat adjustment for
correct operation.
25−10−00
900 Inspect crew restraints for condition and security of attachment to
seats. Do a check of the belt adjusters, buckles, and inertia reels for
correct operation.
25−10−00
900 Inspect crew compartment interior trim for condition and security of
attachment.
25−10−00