CSP−900RMM−2 MD Helicopters, Inc.
Rotorcraft Maintenance Manual
Page 208
Revision 35
05-20-50
Table 202. Inspection 1 − Nose Section and Cockpit (Area 1) (Cont.)
Registration No. Serial No. Helicopter Total Hours
Model InitialRMM SectionRequirement
Doors
900 Inspect left and right crew doors:
condition and damage
door seals for condition and damage
attach hardware and components for damage and security.
52−00−00
900 Do a check of crew door latch mechanisms and crew door hold open
struts for correct operation.
52−00−00
900 Inspect crew door windows and seals for condition, damage, and
correct installation.
52−00−00
Flight Controls
900 Inspect collective, cyclic, and anti−torque flight controls brackets,
bellcranks, links and control rods located under the cockpit floor, and
in the controls closet for condition, indication of interference, correct
installation, and control rod bolts installed in the correct direction.
67−10−00,
Section 1.,
Parts A., D.,
E., G. & H.;
67−20−00
Engine Controls
900 Inspect mechanical engine control interconnect cables, detent
modules, and area control cables for condition and correct
installation.
76−00−00
Environmental Control System
900 Inspect crew gaspers for correct operation and installation. 21−20−00
If optional heat/defog system is installed:
900 Inspect heat/defog system:
valve for condition and security
ejector and ducts for condition and security.
21−40−00
900 Do a check of crew heater control cable for correct operation. 21−40−00
Fire Protection
If optional heat/defog system is installed:
900 Inspect detection control units and electrical connections for condition
and security.
26−10−20
To Next Page