Metcom Solutions MCS301 User Manual

26 M-Bus support Page 120 of 142
MCS301 meter - product Manual 1.25 MetCom Solutions GmbH
26.2 Device ID’s for M-Bus meters
Device ID’s are stored in dedicated COSEM objects from interface class 1. The device ID’s
that have been used in sub meters are as following table:
Device ID
Type
Description
COSEM Object
Remark
M-Bus Device ID 1,
channel 1,2,3,4
Octet-string (0-48) Fabrication
Number
0-b:96.1.0.255 On installation
M-Bus Device ID 2,
channel 1,2,3,4
Octet-string (0-48) Reserved 0-b:96.1.1.255
26.3 M-Bus profile
E-meter saves the load profile of sub-meter for up to 4 M-BUS channels.
Features
Load Profile M-Bus 1,2,3,4
(0-b:24.3.0.255)…..)
Min capacity: At least 52 days for daily recording
Default captured objects: Clock; profile status; M-Bus intances 1 .. 4
Capture period: Choice (60, 300, 600, 900, 1800, 3600,
86400)
Sorted method: Sorted by FIFO, smallest
Selective Access: By range: mandatory
Profile status
The Profile Status provides complementary information about the stored values in profiles
buffer. The HES/MDM system will use this information to decide about the validity of
collected values. The content of Profile Status is captured for every entry (in buffer).
The size of Profile Status is one byte and each bit shows a critical situation in meter as
shown in following figures for different profile status.
ID
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Description Power
Down
Reserved Clock
adjusted
Reserved Daylight
saving
Data not
valid
Clock
invalid
Critical
Error
26.4 Connect/Disconnect for M-Bus meters
Relay Disconnection/Reconnection of sub-meters can be done either remotely or manually
/ locally. In case of need for a scheduled control of relay, it will be handled by COSEM
objects “Discount/Reconnect Control Scheduler”. This schedule can be used for both
disconnection and reconnection of internal relay.

Metcom Solutions MCS301 Specifications

General

Brand	Metcom Solutions
Model	MCS301
Category	Measuring Instruments
Language	English