MIMAKI CFL-605RT - Eccentricity Adjustment Details (Pattern A;B)

6-6
Adjusting the Eccentricity
The eccentricity can be adjusted on the screen below.
(1) Check the position of the horizontal line with respect to the vertical lines on Pattern A.
• Check if the horizontal line protrudes or if there are gaps.
(2) Check if the X and Y axis lines in Pattern B form straight lines.
(3) Make the adjustment.
Adjusting Pattern A Adjusting Pattern B
• When using the 2°x10 carbide reciprocating cutter,
adjust the horizontal line to protrude approx. 2 mm.
Adjusting Pattern A
Aligns the center of the cutter (roller) with the center of
the holder.
Press
or to adjust. (0.01 mm pitch)
Adjusting Pattern B
Adjustment to check whether the tool is tilted.
Press
or to adjust. (0.05 mm pitch)
<CENTER ADJUST>
CENTER A : 0 . 0 0mm
<CENTER ADJUST>
CENTER B : 1 . 0 0mm
Gap
Measure distance A on the diagram.
Press to adjust in the negative
direction to Set value = +A.
Line protrudes
Measure distance A on the diagram.
Press to adjust in the positive
direction to Set value = -A.
Top line displaced to the left
Press to adjust in the negative
direction to Set value = (length B in diagram)
/ 2.
Top line displaced to the right
Press to adjust in the positive
direction to Set value = (length B in
diagram) / 2.