MIMAKI CFL-605RT - Offset Adjustment Details (Pattern X;Y)

6-7
1
1
1
1
Troubleshooting
6
Adjusting the Tools
Adjusting the Offsets
Conduct positioning to correct for displacements by comparing
a test pattern drawn by the pen with a test pattern drawn by the
cutter or roller.
1
Press the key in the local mode.
2
Press the jog key or to select [TOOL
ADJUST] .
3
Press the key.
4
Press the jog key to select tool.
• Set value: REC.CUTTER1~2, CUTTER, ROLLER1~3
5
Press the key.
6
Attach the selected tool ( P.2-22).
7
Press the jog key to select [OFFSET
ADJUST].
8
Press the key.
9
Press key.
10
Press the jog keys to move the head to the drawing position.
11
Press to start drawing the test pattern.
12
Press key to return to the selection of the
adjustment value.
• First, mount a pen in Unit A.
30mm
30mm
Normal
test pattern
<FUNCT ION>


SET UP [ ENT ]
FUNCTION
<FUNCT ION>


TOOL ADJUST [ ENT ]
<TOOL SELTECT>
TOOL : B : REC . CUTTER1
<TOOL SELTECT>
TOOL : B : REC . CUTTER1
<FUNCT ION>
MARK DETECT [ ENT ]
<REC . CUTTER1 ADJ >


OFFSET ADJUST [ ENT ]
<OFFSET ADJUST>


OFFSET X : 0 . 0 0mm
<TEST PATTERN>
DRAW: [ ENT ] POS : [ JOG ]
<CENTER ADJUST>
CENTER A : 1 . 0 0mm
<OFFSET ADJUST>


OFFSET X : 0 . 0 0mm