System Maintenance 19-1
19 System Maintenance
Routine system maintenance shall be carried out by the user. System maintenance after
the warranty has expired is the full responsibility of the owner /operator. The responsibility
for maintenance and management of the product after delivery resides with the customer
who has purchased the product.
If you have any questions, please contact Mindray Customer Service Department or sales
representative.
WARNING:
1.
Only an authorized Mindray service engineer can
perform maintenance not specified in this operator’s
manual.
2.
For the sake of the system performance and safety, you
should perform periodical checks for the system.
19.1 Daily Maintenance
You are responsible for daily maintenance.
19.1.1 Cleaning the System
WARNING:
Before cleaning the system, be sure to turn off the power and
disconnect the power cord from the outlet. If you clean the
system while the power is “On”, it may result in electric
shock.
CAUTION:
Do not spill water or other liquid into the system while you
perform the cleaning. Otherwise it may result in malfunction or
electric shock.
Cleaning the probe
Please refer to the operator’s manual of the corresponding transducer or “12 Probe
and Biopsy” chapter to perform cleaning and disinfection.
Cleaning the probe enclosure and connector:
Tools: mild soapy water , dry soft cloth , soft brush
Method:
a) Use dry soft cloth to wipe out the dust attached to surface of probe, acoustic
head of the probe, connector and probe cable;
b) Remained stain or dust attached to surface of probe cable or connector
should be washed out by cloth with clear water or soapy water, and then
air-dry the probe cable or connector;
c) Use a soft brush to clean the connector, removing dust simultaneously.
To Next Page
Loading...
