3-4 System Preparation
Shut down: To power off the system normally.
Standby Click to enter the standby status.
Cancel: to cancel the operation.
To shut down the system in a direct way if you cannot do it normally:
Press and hold the power button for a long time and the system will power off without
displaying the [Shutdown Confirm] screen. However, shutting down the system this way
may destroy the data.
NOTE:
1.
DO NOT rush shutdown of the system in a direct way. It may destroy the
data.
2.
After the software upgrade, please shut down the system in the normal way
(using “Shut down” method) so as to guarantee a fully update.
3.3.3 Standby
Definition of standby: in a normal environmental temperature and humidity condition, the
system is connected with only one probe while no other external devices or extend
modules are connected, only 3V3_STB and 5V_STB power supply is available and in the
meantime, the standby indicator is in orange.
When the battery capacity is charged to the full capacity, the standby time of the system is
no less than 64 hours.
To enter standby:
Fully fold the LCD display and wait for 30 sec, then the system enters the standby
status.
Open [Setup]→[System Preset]→“General” to set the time for screensaver and
standby. If there is no operation, the system enters screensaver after the waiting
time set for screensaver, and if there is still no operation, the system enters
standby after the waiting time for standby.
Press the power button and select “Standby”.
When the system enters the standby status, the power button backlight turns orange.
To exit standby
Unfold the LCD display.
Press the power button.
When the system enters the standby status, if need to power off:
Long press the power button for 8s.
Press the power button to exit the standby status and then power off the system.
To Next Page
Loading...
