Minebea CSD-912B - Page 101

81
Measurement
5
5.4. Measurement in sequential mode
3) Set the discharge operation on completion of measurement
1. Tap [DISCHARGE START].
7KHVFUHHQWRVHWWKHGLVFKDUJHRSHUDWLRQZLOOEH
displayed.
2. Tap [VALID]/[INHIBIT].
Default: [INHIBIT]
3. Tap [OK].
The discharge operation on completion of
measurement has been set, and the screen to set
>%$7&+),1,6+$&7,216@ZLOOEHGLVSOD\HG
POINT
- If both [MIXING START] and [DISCHARGE START] are set to [VALID], the
PHDVXUHGREMHFWVZLOOEH¿UVWPL[HGWKHQGLVFKDUJHG
(10) [BATCH FINISH OUTPUT ON] settings
6HWWKHRXWSXWWLPHRIEDWFK¿QLVKVLJQDOV
1) Display the screen to set [BATCH FINISH OUTPUT ON]
1. Tap [BATCH FINISH OUTPUT ON] on
[SEQUENCE CONTROL 3/3].
The screen to set [BATCH FINISH OUTPUT ON]
ZLOOEHGLVSOD\HG
6HWWKHRXWSXWWLPHRIEDWFK¿QLVKVLJQDOV
(QWHUWKHRXWSXWWLPHRIEDWFK¿QLVKVLJQDOV
$OORZDEOHUDQJHWR
Default: 0.00
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
7KHRXWSXWWLPHRIEDWFK¿QLVKVLJQDOVKDVEHHQVHW
DQG>6(48(1&(&21752/@ZLOOEHGLVSOD\HG