Minebea CSD-912B - Page 102

82
Measurement
5
5.4. Measurement in sequential mode
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHRXWSXWWLPHRIEDWFK¿QLVK
signals.
The setting is completed if the value set by the step
2) appears under [BATCH FINISH OUTPUT ON].
(11) [BATCH FINISH OUTPUT OFF] settings
6HWWKHFRQGLWLRQWRWXUQRIIWKHRXWSXWRIEDWFK¿QLVKVLJQDOV
1) 'LVSOD\WKHVFUHHQWRVHWFRQGLWLRQWRWXUQRIIWKHRXWSXWRIEDWFK¿QLVKVLJQDOV
1. Tap [BATCH FINISH OUTPUT OFF] on
[SEQUENCE CONTROL 2/3].
The screen to set condition to turn off the output of
EDWFK¿QLVKVLJQDOVZLOOEHGLVSOD\HG
6HWWKHFRQGLWLRQWRWXUQRIIWKHRXWSXWRIEDWFK¿QLVKVLJQDOV
1. Select the condition to turn off the output of
EDWFK¿QLVKVLJQDOV
[NO CONDITION]: Turn off the output of batch
¿QLVKVLJQDOVZKHQWKHWLPHVHWE\>%$7&+),1,6+
OUTPUT ON] elapses or the signals to start next
measurement are input.
[OL OR UNSTABLE]: Turn off the output of batch
¿QLVKVLJQDOVZKHQ>2/@RU>2/@LVGLVSOD\HGRQ
:HLJKLQJVFUHHQRUWKHZHLJKLQJYDOXHEHFRPHV
unstable.
[ZERO BAND]7XUQRIIWKHRXWSXWRIEDWFK¿QLVK
VLJQDOVZKHQWKHZHLJKLQJYDOXHLVHTXDOWRRUOHVV
than the setting value of [ZERO BAND] of [BRAND
CODE].
Default: [NO CONDITION]
POINT
- Refer to "5.11.5. Stable detection
settings" for more information about the
conditions of stability.
2. Tap [OK].
7KHFRQGLWLRQWRWXUQRIIWKHRXWSXWRIEDWFK¿QLVK
signals has been set, and [SEQUENCE CONTROL
@ZLOOEHGLVSOD\HG