Minebea CSD-912B - Page 103

83
Measurement
5
5.4. Measurement in sequential mode
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHFRQGLWLRQWRWXUQRIIWKHRXWSXWRI
EDWFK¿QLVKVLJQDOV
The setting is completed if the item set by the step
2) appears under [BATCH FINISH OUTPUT OFF].
(12) [BATCH MONITORING TIMER] settings
6HWWKHWLPHUWRPRQLWRUWKHWLPHEHWZHHQWKHVWDUWVLJQDOLQSXWDQGWKH¿QLVKVLJQDORXWSXW
$QHUURUZLOORFFXUZLWK>64(55@EHLQJGLVSOD\HGLIWKHPHDVXUHPHQWODVWVORQJHUWKDQWKH
settings of the monitoring timer.
POINT
- Measurement time is monitored if [CONTROL MODE] is [BATCH MODE]. -
Refer to "5.4.2. Measurement in sequential batch mode" for more information
about the sequential batch mode.
- Refer to "11.2.3. Sequence error display" for more information about error display.
1) Display the screen to set [BATCH MONITORING TIMER]
1. Tap [BATCH MONITORING TIMER] on
[SEQUENCE CONTROL 2/3].
The screen to set [BATCH MONITORING TIMER]
ZLOOEHGLVSOD\HG
2) Set the timer to monitor measurement time
1. Enter the time of the monitoring timer.
$OORZDEOHUDQJHWR
Default: 0
POINT
- Setting [0] does not monitor
measurement time.
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
The monitoring timer has been set, and
>6(48(1&(&21752/@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRIWKHPRQLWRULQJWLPHU
The setting is completed if the value set by the step
2) appears under [BATCH MONITORING TIMER].