Minebea CSD-912B - Page 153

133
Measurement
5
5.9. Measurement in 4 steps comparator mode
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHFRPSDULVRQFRQGLWLRQ
The setting is completed if the item set by the step
2) appears under [CONDITION OF S1].
POINT
- To set comparison conditions for Condition2 to Condition4, tap [CONDITION OF
S2] to [CONDITION OF S4] and repeat the same operation.
(4) Settings of the value of [ZERO BAND]
6HWWKHYDOXHLQZKLFKWKHZHLJKLQJYDOXHLVGHWHUPLQHGDV(QWHUWKHVHWWLQJVDVQHHGHG
1) Display the screen to set the value of [ZERO BAND]
1. Tap [ZERO BAND] on [COMPARATOR 2/2].
7KHVFUHHQWRVHWWKHYDOXHRI>=(52%$1'@ZLOOEH
displayed.
2) Set the value of [ZERO BAND]
1. Enter the value of [ZERO BAND].
$OORZDEOHUDQJHWR
Default: 0
POINT
- Refer to "3.5. Input of numerical values"
IRUPRUHLQIRUPDWLRQDERXWKRZWRHQWHU
numerical values.
2. Tap [OK].
The value of [ZERO BAND] has been set, and
>&203$5$725@ZLOOEHGLVSOD\HG
&RQ¿UPWKHVHWWLQJV
&RQ¿UPWKHYDOXHRI>=(52%$1'@
The setting is completed if the value set by the step
2) appears under [ZERO BAND].