364
Tally Interface Devices
Kayenne Production Switcher
Assigning Kayenne Tallies, Input Names, and Output Names to Logical Sources
The Kayenne contribution tally protocol provides information on up to 96 external sources,
up to
4 eDPM video/key pairs, up to 6 image store outputs, up to 48 programmable
switcher outputs, up to 2 complete operator suites with the associated alternative source
names, and a few more signals from the Kayenne Video Processor Frame. In XEdit’s
Channels/Sources tab, configure logical sources using text sources and system tallies from
the Kayenne’s serial interface. You will find these elements by expanding the filtered system
list that appears in the Tools pane.
To configure your logical sources
1In the Channels/Sources tab, add the required number of text and alarm levels for your
purposes (see
Creating and Configuring Logical Sources, on page 157).
You may, for example, add one text level to monitor source labels from the Kayenne
switcher, and two alarm levels to monitor Program and Preview tallies.
2 Click a cell that corresponds to the appropriate text level of a logical source.
3 In the filtered System list, navigate to the text element you wish to monitor, and drag it
onto the selected cell.
3 Pgm C 15 ME1 C 27 ME2 C 39 ME3 C
4 Pgm D 16 ME1 D 28 ME2 D 40 ME3 D
5 Pgm pA 17 ME1 pA 29 ME2 pA 41 ME3 pA
6 Pgm p2 18 ME1 p2 30 ME2 p2 42 ME3 p2
7 Aux 1 19 Aux 4 31 Aux 8 43 Aux 14
8 Aux 1 20 Aux 4 32 Aux 9 44 Aux 15
9 Aux 2 21 Aux 5 33 Aux 10 45 Aux 16
10 Aux 2 22 Aux 6 34 Aux 11 46 Aux 17
11 Aux 3 23 Aux 7 35 Aux 12 47 Aux 18
12 Aux 3 24 Sw Pvw 36 Aux 13 48 Aux 19
ME A ME B ME C ME D
Output # Signal Output # Signal Output # Signal Output # Signal
To Next Page
Loading...
