171
17.4.21. Ethernet
You can set robot controller Ethernet information.
This function can be used with Version 3.2 or later of this software.
Select the device to edit and double tap. A screen is displayed for setting a variety of device information.
If you select [MELFA-3D Vision] or [Network Vision Sensor (2D)] at [Auto configuration], the default value
corresponding to each device is set to items below [Mode].
Using a CRn-500 series robot controller
When using Ethernet with a CRn-500 series robot controller, the "Ethernet interface" option
is required.
CAUTION
To Next Page
Loading...
