176
17.4.26. Work coordinate
Work coordinate parameter defines coordinates used with the WORK jog. 8 work coordinates can be defined.
The WORK jog function is available with Ver.2.3 or later of this software. Moreover, the software version of the
controller which can use this function is as follows.
Controller S/W Ver. of the controller
CR750-D/CRnD-700 Ver.P8 or later
CR750-Q/CRnQ-700 Ver.N8 or later
The work coordinate is defined by 3 points; “Origin WO”, “+X WX”, and “+Y WY”.
To Next Page
Loading...
