86
13.9. Select program
Even the controller which the operation panel is not installed can select the program from this T/B.
This function is available with Ver.2.3 or later of this software.
1) If the operation panel is installed on the controller, set the controller [MODE] switch to "AUTOMATIC".
2) Make the T/B enable.
(Push the [TEACH] switch of T/B, and confirm that the [TEACH] switch and the [TB ENABLE] lamps light.)
3) Select the program used for automatic operation from the program list. (<a>)
4) Tap the [Select] button. (<b>) The confirmation message will be displayed. Tap the [Yes] and the state of the
program can be operated automatically.
<a>
<b>
To Next Page
Loading...
