Mitsubishi R56TB - Initializing SQ Direct Position Data

69
11.3.4. Initialization of position data for SQ Direct Function
Select the position data to initialize (<a>), and tap the [Delete] button (<b>). The confirmation message is shown up,
after that tap the [Yes] button. The values of selected position data are initialized.
11.3.5. Confirming the position data for SQ Direct Function (Position jump )
The robot can be moved to the teaching position and the position can be checked.
Please refer to “11.2.5 Confirming the position data (Position jump)” fo
r detail operation.
11.3.6. Saving the position data for SQ Direct Function to USB
Position data for SQ Direct Function cannot be saved to the USB memory from the SQ Direct position edit screen
of controller.
Tap the [Program list] button, display the Program list screen and use the copy function. Please refer to “11.3.7
Copy position data for SQ Direct Function from controller to USB” for det
ails.
When the [Yes] button of the confirmation message is tapped, the position data of the selected
position variable are initialized (cleared) in the controller.
C
A
U
TI
O
N
<b>
<a>