196
19.1.5.2. Lamp
(1) Tap the position (block) in which the lamp is made (<a>). The lamp is arranged at this position.
(2) After “Select item” window is displayed, tap [Lamp] button (<b>).
(3) Select the lighting color of the lamp on “Create lamp” window.
(4) Tap [On/Off condition] button (<c>), and set the lighting condition and the turning off condition on "The
lamp on/off condition” window.
Signal number can be set by [Signal No.] button (<e>). After setting the lighting condition and the turning
off condition, tap [OK] button (<f>). The set content is displayed (<d>) in the right of the [On/Off
condition] button.
(5) After setting the lamp color and lighting condition and the turning off condition, tap [OK] button (<g>).
<1> Lamp color : The lighting color of the lamp can be selected.
<2> Setting : The condition of turning on / turning off the lamp can be set.
If only one condition is set, the lamp is operated like the other condition is set the
opposite High/Low state to the same signal number.
Moreover, when both the ON condition and the OFF condition are true, the ON condition
is given priority.
<a>
<b>
<1>
<2>
<g>
<e>
<f>
<c>
<d>
To Next Page
Loading...
