Mitsubishi R56TB - Lamp ON;OFF Condition Settings

197
Example of setting lamp ON/OFF
For example:
Lamp that is turned on when the input signal number 20 is High, and is turned off when the input signal
number 20 is Low.
(1) A default value of “The Lamp
on/off condition” window is
shown in a right picture.
(2) Set “On condition”.
Tap <h>, and Select the signal
type.
Now, select “input signal”.
(3) Tap [Signal No.] button (<j>),
and set “20” to signal number
(<i>).
(4) Select "High" (<k>), as a state
of signal to light the lamp.
(5) Similarly, set the condition for
turning off the lamp, and tap
[OK] button (<l>).
<h>
<j>
<i>
<k>
<l>