173
17.4.23. CC-Link
Set the information of CC-Link in the robot controller.
This function can be used with Version 3.2 or later of this software.
This function can only be used with a CRn-500 series or CRnD-700 series robot controller.
Also, this function cannot be used with CRnQ-700 series robot controller. If you use
CRnQ-700 series robot controller, please set it with the software of the PLC.
CAUTION
You can reset the error of the CC-Link interface card by tapping the [Err. Cancel] button. After that the same
error doesn't occur. It is valid while the power supply of the Robot Controller is ON. When the power supply is
turned OFF, the error comes to occur.
To Next Page
Loading...
