132
16.5.5. Setup
Tap the Setup button.
Here, the timing to collect the information for Maintenance Forecast, the notification method and other items
can be set up.
When the [W
rite Parameters] button (<a>) i
s tapped
after setting each item, the setting values a
re written
into the controller. All items other than the signal numbers of dedicated outputs take effect after they are
written into the controller. If a dedicated output signal has been changed, it is necessary to power on the
controller again.
For more information about the setup items, see “Tab. Setup Screen”
Information needed to “Maintenance Forecast” is not accumulated
while the Maintenance forecast is being invalidly set.
Factory preset value is invalidity. When the
Maintenance Forecast is invalidated, information
of Maintenance Forecast is not accumulated.
When switched effectively from invalidity again,
the reservoir of information is continued from the
last value. If you have invalidated the
Maintenance Forecast for a long term,
the
correct maintenance times cannot be
calculated.
CAUTION
invalidity
Information is accumulated.
Maintenance Forecast
Effective
Reservoir of information
time
<a>
To Next Page
Loading...
Need help?
General
