Mitsubishi R56TB - Operating the User Definition Screen

212
19.2. Operation of user definition screen
The user definition screen can be displayed by the following operations.
(1) Tap the [MENU] button (<a>) of a T/B screen and display menu panel.
(2) Tap the [User Definition] button (<b>) in the menu.
(3) The user definition screen is displayed.
<1> User definition screen : The registered user definition screen is displayed.
On this screen, you can change the value of the variable parts set value edit
Enable by tapping this parts and displaying the input value screen. (Only at
T/B state is enabling.)
<2> Page name : The name of the user definition screen is displayed.
<3>
<4>
: The page is switched.
<a>
<b>
<2>
<3> <4>
<1>
(Note) “User definition screen” is supported by
version 2.2 or later of this software.
The signal can be output only in the T/B enabling state when the button is
tapped.
Enable the T/B state when the signal is outputted by the button which registered on the user
definition screen. Please note that the signal cannot be output in the T/B disabling state.
The state of the signal can be seen to regardless of the state of T/B.
CAUTION