218
20.8. Reset
The [Reset] button (<a>) can be reset the controller’s error. This also resets the program's halted state and resets
the program.
At program reset
Tap the [Reset] button (<a>), the confirmation message box (<b>) is displayed. Tap the [Yes] button (<c>), the
program is reset.
20.9. Cycle stop
If the [Cycle Stop] button (<a>) is tapped during the continuous operation, the program will stop after one cycle.
The lamp (<b>) blinks during the cycle stop.
It returns to a continuous operation when the [Cycle Stop] button (<a >) is tapped again during cycle stop.
<a>
<b>
<a>
<c>
<b>
To Next Page
Loading...
