MR ETOS IM - Page 265

7 Operation
Maschinenfabrik Reinhausen GmbH 2019 2655163667/06 EN ETOS
®
IM
ASDU address
You can use this parameter to set the address of the ASDU.
To set the ASDU address, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-103 > ASDU address.
2. Set ASDU address.
3. Press the Accept button to save the modified parameter.
Number of data bits
You can use this parameter to set the number of databits.
To set the number of data bits, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-103 > Number of data bits.
2. Set number of data bits.
3. Press the Accept button to save the modified parameter.
Parity
You can use this parameter to set the parity. You can select the following
options:
▪ None
▪ Even
▪ Odd
To set the parity, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-103 > Parity.
2. Select parity.
3. Press the Accept button to save the modified parameter.
Number of stop bits
You can use this parameter to set the number of stop bits.
To set the number of stop bits, proceed as follows:
1. Go to Settings > Parameters > IEC 60870-5-103 > Number of stop bits.
2. Set number of stop bits.
3. Press the Accept button to save the modified parameter.