MR ETOS IM - User Administration and Roles

7 Operation
Maschinenfabrik Reinhausen GmbH 2019 2955163667/06 EN ETOS
®
IM
7.25.5 Automatic switchover between daylight saving time and
standard time
You can use this parameter to activate the automatic switchover between
daylight saving time and standard time. Depending on the time zone (region)
set, the device switches automatically between daylight saving time and
standard time on the specified days.
To set the automatic switchover between daylight saving time and standard
time, proceed as follows:
1. Go to Settings > Parameters > Time synchronization > Automatic
daylight saving / standard time.
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
7.25.6 Setting the date and time manually
You can use the Time parameter to set the date and time. To do so, proceed
as follows:
1. Go to Settings > Parameters > Time synchronization > Time.
2. Enter the date and time.
3. Press the Accept button to save the modified parameter.
7.26 User administration
User administration is based on a system of roles. You must assign a role to
every user. You can define access rights to parameters and events for each
role.
7.26.1 User roles
The access rights to device functions and settings are controlled using a hi-
erarchical system of roles. The system has 5 different roles with different ac-
cess rights. Some of these access rights are fixed, but you can configure the
access rights to particular parameters and events. Note the Setting access
rights to parameters and events [►Section 7.26.4, Page 300] section.
If you are not logged in on the device, you will assume the "Data display"
user role.