MR ETOS IM - Device Event Messages; Overview of Event Messages

9 Messages
Maschinenfabrik Reinhausen GmbH 2019 3355163667/06 EN ETOS
®
IM
9 Messages
9.1 Event messages
This chapter provides an overview of the device event messages. The avail-
ability of individual event messages varies depending on your device func-
tion.
No. Name Description Remedy Q
1
1 Limit value U< Value has fallen below the limit
value for undervoltage U<.
Check the current operating con-
ditions of the transformer and the
set U< parameters.
-
2 Limit value U<< Value has fallen below the limit
value for undervoltage U<<.
Check the current operating con-
ditions of the transformer and the
set U<< parameters.
-
3 Limit value U> The limit value for overvoltage U>
has been exceeded.
Check the current operating con-
ditions of the transformer and the
set U> parameters.
-
4 Limit value U>> The limit value for overvoltage
U>> has been exceeded.
Check the current operating con-
ditions of the transformer and the
set U>> parameters.
-
5 Limit value I< Value has fallen below the limit
value for undercurrent I<.
Check the current operating con-
ditions of the transformer and the
set I< parameters.
-
6 Limit value I<< Value has fallen below the limit
value for undercurrent I<<.
Check the current operating con-
ditions of the transformer and the
set I<< parameters.
-
7 Limit value I> The limit value for overcurrent I>
has been exceeded.
Check the current operating con-
ditions of the transformer and the
set I> parameters.
-
8 Limit value I>> The limit value for overcurrent I>>
has been exceeded.
Check the current operating con-
ditions of the transformer and the
set I>> parameters.
-
9 Limit value S< Value has fallen below the limit
value for apparent power S<.
Check the current operating con-
ditions of the transformer and the
set S< parameters.
-
10 Limit value S<< Value has fallen below the limit
value for apparent power S<<.
Check the current operating con-
ditions of the transformer and the
set S<< parameters.
-
11 Limit value S> The limit value for apparent
power S> has been exceeded.
Check the current operating con-
ditions of the transformer and the
set S> parameters.
-
12 Limit value S>> The limit value for apparent
power S>> has been exceeded.
Check the current operating con-
ditions of the transformer and the
set S>> parameters.
-
13 Limit value P< Value has fallen below the limit
value for active power P<.
Check the current operating con-
ditions of the transformer and the
set P< parameters.
-