7 Operation
Maschinenfabrik Reinhausen GmbH 201996 5163667/06 ENETOS
®
IM
7.2.4 Transformer name
You can use this parameter to enter a transformer name for identification
purposes.
1. Go to Settings > Parameters > General > Transformer name.
2. Enter transformer name.
3. Press the Accept button to save the modified parameter.
7.2.5 Remote behavior
You can use this parameter to select the behavior of the device in remote
operating mode. You can select the following options:
Option Description
Hardware only The device accepts commands via digital inputs.
SCADA only The device accepts commands via SCADA.
Hardware and SCADA The device accepts commands via digital inputs and
SCADA.
Table15: Selecting Remote behavior
To set the Remote behavior, proceed as follows:
1. Go to Settings > Parameters > General > Remote behavior.
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
7.2.6 Accessing online help
The web-based visualization has an online help section. To call up the online
help, proceed as follows:
1. Call up the web-based visualization with the PC.
2. Select the MR logo in the status line.
ð The online help appears.
7.2.7 Activating/deactivating the USB interface
This parameter lets you deactivate the USB interface. You can select the fol-
lowing options:
▪ On: USB interface is activated
▪ Off: USB interface is deactivated
Proceed as follows to activate/deactivate the USB interface:
1. Go to Settings > Parameters > General > USB interface.
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
To Next Page
Loading...
