MR ETOS IM - Setting the Time Zone; Setting Synchronization Interval

7 Operation
Maschinenfabrik Reinhausen GmbH 2019294 5163667/06 ENETOS
®
IM
Entering time server address of second time server (optional)
You can use this parameter to enter the IP address of the second time
server as an option.
To enter the time server address of the second SNTP server, proceed as fol-
lows:
1. Go to Settings > Parameters > Time synchronization > SNTP time
server 2.
2. Enter time server address.
3. Press the Accept button to save the modified parameter.
7.25.3 Setting the time zone
If the time information is conveyed to the device by a network service (SNTP
or SCADA), this time is transferred depending on the set reference time. To
adjust the device time to your local time, you can use the time shift parame-
ter to set the time shift to UTC.
Example:
Region Time shift to UTC
Mumbai, India UTC +5:30h
Beijing, China UTC +8:00h
Brasilia, Brazil UTC -3:00h
Table85: Time shift to UTC (Coordinated Universal Time)
To set the time zone, proceed as follows:
1. Go to Settings > Parameters > Time synchronization > Time zone.
2. Select the option you want.
3. Press the Accept button to save the modified parameter.
7.25.4 Setting synchronization interval
You can use this parameter to set the interval at which the device is to call
up the time from the time server.
To set the synchronization interval, proceed as follows:
1. Go to Settings > Parameters > Time synchronization > Synchroniza-
tion interval.
2. Enter synchronization interval.
3. Press the Accept button to save the modified parameter.