MR ETOS IM - Page 67

5 Mounting
Maschinenfabrik Reinhausen GmbH 2019 675163667/06 EN ETOS
®
IM
3. As an alternative to step 2, connect the COM2 interface (D-Sub 9-pole) to
the control system (SCADA) in accordance with the connection diagram.
Figure50: Serial SCADA connection via COM 2 interface
Voltage supply
You have to connect the CPU component to the voltage supply of the volt-
age supply unit. Proceed as follows:
1. Guide the leads into the plug terminal and fasten them using a screw-
driver.
Figure51: Inserting the leads