Choose DNP3 Configuration:
A / B / C
Choose Measurement Units:
Imperial/Metric
Select the Number of MultiSmart
Units in the Pump Station
Select Type of Board Installed
in Unit 1:
3PC / 3MP / None
Choose the Type of Level Device
used by the Reservoir:
Probe / Analog
Set Supply Voltage:
480V / 415V / 240V / 208V
or Enter Custom Value
DNP3 Address Setup
Check Setup Summary
Yes / No
Return to Select Station Type
Screen in Setup Wizard Drawing
No
New Settings applied
and Unit Restarted
Yes
To Next Page
Loading...
