EasyManua.ls Logo

NEC DSX - Park; Using Park at a Keyset

NEC DSX
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Park
Park a call in orbit so a co-worker can pick it up. You don't have to locate a co-worker to handle their calls.
You can place an outside call in a waiting state (called a Park Orbit) so that a co-worker may pick it up. There are two types
of Park: System and Personal. Use System Park when you want to have the call wait in one of 10 system orbits (60-69). Use
Personal Park to Park a call at a co-worker's extension. After parking a call, you normally Page your co-worker to pick it up.
Your co-worker dials a code or presses a programmed System Park key to retrieve the call.
A call you Park too long will recall to you and then divert to other extensions in your system.
If you have a System Park key on your phone, the key shows you the status of the assigned system orbit.
Park Key Busy Lamp Indications
The Park orbit is:
When the key is:
IdleOff
A co-worker has parked a call in the orbit assigned to the
key.
On (red)
The extension user has parked a call in the orbit assigned
to the key.
Single wink on (green)
Using Park at a Keyset
To Park a call from a keyset:
1. Do one of the following for System Park.
a) Push
Park + Sys + Dial the System Park Orbit number (0-9).
b) Push the System Park Orbit key.
c) Press TRANSFER + Dial * + Dial the System Park Orbit (60-69).
2. Do one of the following for Personal Park:
a) Push Park + Pers + Dial the number of the extension at which you want to Park the call.
b) Press TRANSFER + Dial ** + Dial the number of the extension at which you want to Park the call.
The line/loop key for the parked call winks on (green) at your extension.
To retrieve a parked call from a keyset:
1. Do one of the following for System Park.
a) Push the System Park Orbit key.
b) Press
INTERCOM + Dial * + Dial the System Park Orbit (60-69).
2. Do one of the following for Personal Park:
a) Press INTERCOM + Dial ** + Dial the number of the extension at which the call is Parked.
The line/loop key for the parked call winks on (green) at your extension.
b) Press the ashing line/loop key.
DSX | Features | 147
XML to PDF by RenderX XEP XSL-FO Formatter, visit us at http://www.renderx.com/

Table of Contents

Other manuals for NEC DSX

Related product manuals